Technical News
Find what you need fast and easily
June 2019
6/28/2019
Corrections made on hinges machinings (pages 98-107)
6/26/2019
Profiles and accessories are available. Note that in order for the typology to function properly, you must not use reinforced interlocking profiles where the fly screen is placed. For example, if the fly screen is placed on the outside track, you can only use reinforced interlock profile in the inner part of the section and vice versa. For heights more than 2.4m, a special corner cleat can be used (145-11-260-00), which creates a tension on the vertical profiles of the fly screen in order to keep the fly mesh stretched at all times. The specific corner which is patented should be used in combination with a steel rod, which will bend at the opposite direction of the deflection created due to the tension of the fly mesh, thus keeping the vertical fly screen profiles straight. This tension is created by a screw into the corner. By screwing, the rod will bend, and thus we can adjust the vertical alignment of the profiles. Attached you can find the typology in pdf and AutoCAD sections.
6/21/2019
The following changes were made to the catalog:
- changes in all even typologies
- profil cuttings and accessory quantities added on corner typology
6/21/2019
We have developed 2 new triple_track profiles for S650. The new track profiles are joint together with 3 sets of polyamides, thus offering a single profile code for the 3 track typology. Up until today, the 3 track profile was only feasible by joining together 3 different profiles. Now, we can have only one profile code for these tracks.
Note: The total width of these profiles is 250mm, so cutting can only be done with appropriate saw, able to cut this profile dimension. Fabricators can explore the possibility of cutting these profiles according to their saw machines.
6/21/2019
New reinforcement profile for M7 mullion