Technical News

Find what you need fast and easily

July 2019

7/9/2019

We would like to inform you that ALUMIL has developed a new profile, 303031, which is placed at the bottom of the rolling shutter, clicked on the terminal profile, to increase its overall mechanical performance.

This profile co-operates only with 35009 terminal profile and significantly enhances the shutter sturdiness and wind load resistance. The profile is accompanied by a pair of plastic caps, EX- 7653030100, as below. Both profiles and the corresponding caps are available for order.

Standard lengths

Furthermore, there has been a change in the standard length of two slats, meaning that M1011(77mm) and 303028 (55mm) slats are now available in 6.6m standard length.

7/4/2019

Bi-folding door SF85 | New certificate

We have a new certificate for our SF85 bi-folding door, 3+0 typology. We have managed to increase the water tightness to 9A (600Pa) adding a subsil. Attached you can find the first page the test.

June 2019

6/28/2019

Renewal of the SD77 technical catalog

Corrections made on hinges machinings (pages 98-107)

6/26/2019

Fly screen typology for S650

Profiles and accessories are available. Note that in order for the typology to function properly, you must not use reinforced interlocking profiles where the fly screen is placed. For example, if the fly screen is placed on the outside track, you can only use reinforced interlock profile in the inner part of the section and vice versa. For heights more than 2.4m, a special corner cleat can be used (145-11-260-00), which creates a tension on the vertical profiles of the fly screen in order to keep the fly mesh stretched at all times. The specific corner which is patented should be used in combination with a steel rod, which will bend at the opposite direction of the deflection created due to the tension of the fly mesh, thus keeping the vertical fly screen profiles straight. This tension is created by a screw into the corner. By screwing, the rod will bend, and thus we can adjust the vertical alignment of the profiles. Attached you can find the typology in pdf and AutoCAD sections.

6/21/2019

Renewal of the SF85 technical catalog

The following changes were made to the catalog:

changes in all even typologies
profil cuttings and accessory quantities added on corner typology

6/21/2019

SUPREME S650 | New 3 track joint profiles

We have developed 2 new triple_track profiles for S650. The new track profiles are joint together with 3 sets of polyamides, thus offering a single profile code for the 3 track typology. Up until today, the 3 track profile was only feasible by joining together 3 different profiles. Now, we can have only one profile code for these tracks.

Note: The total width of these profiles is 250mm, so cutting can only be done with appropriate saw, able to cut this profile dimension. Fabricators can explore the possibility of cutting these profiles according to their saw machines.

6/21/2019

SUPREME S650 | Protection of upper locking

New accessory for SUPREME S650

6/21/2019

SMARTIA M7 | New reinforcement profile for mullion

New reinforcement profile for M7 mullion

6/21/2019

SMARTIA M7 | New Glass support

M7 T-Shaped / L-Shaped support for heavy glass units

6/14/2019

Renewal of S67 technical catalog

New diagramm on "Sash dimension constraints" chapter